Where is the active filter installed?
active filter device:
when designing the installation of active filter, the appropriate device location should be selected according to the different theater power distribution system and load conditions. There are three options for device location under normal conditions:
1. The centralized management method can filter all low-voltage nonlinear loads. Suitable for non-linear load is more dispersed, a single load capacity of small places. The filter is installed in the low-voltage distribution room.
2. In the group management mode, the active power filter device is installed in the secondary low-voltage distribution board, which is suitable for the place where the non-linear load is relatively concentrated.
3. The local management method is applicable to the place where a single nonlinear load produces large harmonic distortion and the distribution is relatively scattered, and the active power filter device is on the nonlinear load side.
The closer the device of the active filter is to the harmonic source, the better the filtering effect. This is the best way to reduce the harmonic current and wave voltage distortion. Due to the sensitivity of the position of the active power filter device, the best harmonic management effect can be achieved according to the design requirements.
MORE NEWS
The live broadcast of the exhibition │ Hisrec will meet you at the 13th Power Quality Summit Forum.
2019/09/11
2019/09/20
2019/09/20
Follow us
Hotline
400-830-3586
Shenzhen Headquarters
Add:313, Building B, Chuangjin 1, No. 125 Chuangye 2nd Road, Bao'an District, Shenzhen
Tel:+86-755-23890707
Fax:+86-755-23883586-806
Wuhan Branch
Add:Building 5, No. 9 Fozuling Fourth Road, Donghu New Technology Development Zone, Wuhan
Tel:+86-27-81808069
Fax:+86-27-81808069-622
Business email:sales@hisrec.com
HR email:hr@hisrec.com
Copyright © 2022 Shenzhen Hisrec Electrical Technology Co., Ltd. All rights reserved.